KwikSeal® MB™ WoodBinder®

Fastener designed to attach steel roofing & siding used in post-frame & residential metal roofing applications.

Threads transition from fine to coarse to generate superior holding strength in various wood substrates.

Micro-Bit™ point reduces metal shavings that can embed themselves in the rubber washer.

EPDM rubber is vulcanized to a steel washer to form an excellent seal even when driven at an angle.

NOTES:

  1. 1-1 /2” LENGTH FULLY PENETRATES OSB AND PLYWOOD SHEETING
  2. 26 AND 29 GA. VALUES SHOWN WERE OBTAINED USING 80 KSI STEEL SHEETING. 24, 22, AND 20 GA. VALUES WERE OBTAINED USING 50 KSI MINIMUM STEEL SHEETING.
  3. BMT DENOTES BASE METAL THICKNESS AFTER REMOVAL OF PAINT FINISH AND METALLIC PROTECTIVE COATING.
  4. ALL STRENGTH VALUES SHOWN ARE ULTIMATE VALUES, EXPRESSED IN LBS. APPLY AN APPROPRIATE SAFETY FACTOR TO OBTAIN DESIGN LIMITS.

FOR PROPER INSTALLATION, THE USE OF IMPACT DRIVERS ARE NOT RECOMMENDED FOR POWDER COATED OR ANY WET-PAINTED FASTENER.

PULLOUT & PULLOVER VALUES ARE DETERMINED IN THE ST FASTENING SYSTEMS ENGINEERING LABORATORY USING STEEL PANELS/FRAMING & WOOD DENSITIES WHOSE STRUCTURAL PROPERTIES ARE FOUND IN PRESENT DAY PRODUCTS.

2.5 mil of computer controlled powder coat is applied over zinc plating and chromate sealer.

Unique polyester powder formulation resists harmful UV rays and chemical breakdown.

Automated process ensures a consistent color match from batch to batch.

POWDERFUL is completely free of volatile organic compounds (VOC), and is entirely recyclable.

There are 35 standard colors that match high volume metal panel paint colors.

HWH with V-neck design adds strength to prevent head twist off under extreme torque.

UV resistant EPDM rubber is vulcanized to a G-90 steel backed washer to provide maximum sealing ability, which prevents leaks, even when drilled at an angle.

High tensile steel washer provides excellent pullover strength.

ST MAGNETIC SOCKETS are designed with an advanced forging process to fit the painted fastener securely, which helps to prevent fastener wobble upon installation.

Fastener thread transitions from fine to coarse. The low root design provides excellent pullout strength versus traditional or HI-LO thread forms.

Drill point design consistently penetrates metal panels, which eliminates the need to “punch” the metal panels with a sharp point to start the drilling process.

MB point is excellent for penetrating multiple thicknesses of steel often found on ridge cap or trim applications.